Breville / Sage Barista Touch Impress error codes
18 codes. The Barista Touch Impress has single ThermoJet heater; most codes are one of its temperature sensors, a water-level or flow fault, or the grinder.
The Impress shares its control board family and code table with the Barista Touch BES880, so fixes are the same.
How to read the stored error log
Unplug the machine. Press and hold the Power button while plugging it back in. When the password screen appears, enter 02015 to open Service Mode, then open the error log.
Service menus are intended for technicians. Reading the log is harmless; do not change calibration values.
All codes
| Code | Meaning | Fault | DIY |
|---|---|---|---|
ER01 | Ferro heater temperature sensor open circuit detected at startup | Temperature sensor open circuit (not detected) | moderate |
ER02 | Ferro heater temperature sensor open circuit detected during operation | Temperature sensor open circuit (not detected) | moderate |
ER03 | Ferro heater temperature sensor short circuit detected at startup | Temperature sensor short circuit | moderate |
ER04 | Ferro heater temperature sensor short circuit detected during operation | Temperature sensor short circuit | moderate |
ER05 | Milk jug temperature sensor open circuit detected at startup | Temperature sensor open circuit (not detected) | moderate |
ER06 | Milk jug temperature sensor open circuit detected during operation | Temperature sensor open circuit (not detected) | moderate |
ER07 | Milk jug temperature sensor short circuit detected at startup | Temperature sensor short circuit | moderate |
ER08 | Milk jug temperature sensor short circuit detected during operation | Temperature sensor short circuit | moderate |
ER09 | Inline temperature sensor open circuit detected at startup | Temperature sensor open circuit (not detected) | moderate |
ER10 | Inline temperature sensor open circuit detected during operation | Temperature sensor open circuit (not detected) | moderate |
ER11 | Inline temperature sensor short circuit detected at startup | Temperature sensor short circuit | moderate |
ER12 | Inline temperature sensor short circuit detected during operation | Temperature sensor short circuit | moderate |
ER13 | Flow meter count error detected at startup, indicating a water measurement issue | Flow meter signal problem | moderate |
ER14 | Flow meter count error detected during operation, indicating a water measurement issue | Flow meter signal problem | moderate |
ER15 | Communication fault detected between internal electronic modules | Internal communication fault | moderate |
ER16 | Grinder motor overheated and was shut down for protection | Grinder motor fault | easy |
ER17 | Grinder motor operation timed out before completing its task | Grinder motor fault | easy |
ER18 | E-fast protection triggered due to a detected electrical or safety fault | Electrical safety protection triggered | not recommended |