The Breville / Sage Barista Touch Impress shows this code with identical meaning and fix as the Barista Touch. Full guide for ER08.
Applies to: Barista Touch Impress.
How to fix ER08
- Switch off at the wall and unplug. Leave the machine for an hour so any moisture dries, then try again. A short that clears after drying suggests a leak to find.
- Dry the milk sensor area on the drip tray and wipe away any milk residue with a dry cloth. Do not take the machine apart.
- A technician would replace any leaking o-rings at the boiler fittings and sensor probes; the leak, not the sensor, may be the true fault.
- If the code persists after everything is dry, the milk jug temperature sensor (NTC) needs replacing by a technician.
- Afterwards, clear the error log and run a full heat-up and a shot to confirm.
When to stop and call a repairer
If you see scorch marks, smell burning, or the machine trips your GFCI / RCD, stop: that is an electrical fault, not just a sensor.
What it costs
| Parts | Not published by Breville. Ask an authorised service centre for a quote. |
|---|---|
| Service | Not published by Breville. Ask an authorised service centre for a quote. |
| Worth repairing? | Often yes, but Breville does not publish repair costs. If a leak has soaked the control board, get a quote before spending anything. |
How to check the error log
Unplug the machine. Press and hold the Power button while plugging it back in. When the password screen appears, enter 02015 to open Service Mode, then open the error log.
Clear the log after a repair so you can tell whether the fault has really gone.
Beyond the fix
Further reading
Questions
What does ER08 mean on the Breville / Sage Barista Touch Impress?
Milk jug temperature sensor short circuit detected during operation. The milk jug temperature sensor (NTC) is reading as a short circuit: the board sees near-zero resistance, which a healthy sensor does not produce. Technician sources name water bridging the sensor contacts (a leak or steam at the probe seal) and a failed sensor as the likely causes. Because it happened during operation, heat or steam reaching the connector is a plausible cause. Breville does not publish this code table, so the meaning comes from third-party service tables.
Can I fix ER08 myself?
DIY difficulty: hard. Switch off at the wall and unplug. Leave the machine for an hour so any moisture dries, then try again. A short that clears after drying suggests a leak to find. Dry the milk sensor area on the drip tray and wipe away any milk residue with a dry cloth. Do not take the machine apart.
How much does it cost to fix ER08?
Not published by Breville. Ask an authorised service centre for a quote. Not published by Breville. Ask an authorised service centre for a quote.
Is it worth repairing?
Often yes, but Breville does not publish repair costs. If a leak has soaked the control board, get a quote before spending anything.
When does ER08 typically show up?
Breville / Sage Barista Touch Impresss report ER08 while brewing or steaming. That timing is a useful clue when narrowing the cause.
Can I keep using the machine with ER08 showing?
Usually you can finish the drink you are making, but do not ignore it — the underlying fault rarely heals itself. Work through the cheap checks first.
Will ER08 clear on its own?
Rarely. A reset or power cycle is worth one try, but ER08 with a "hard" difficulty rating almost always means a failed component that has to be replaced.
How long does the repair take?
This one is a bench repair for most owners — the teardown, test and reassembly are the bulk of the work, not the part itself.