Applies to: Oracle Jet.
How to fix E19
- Unplug. Do not keep resetting the breaker; each trip means current is going where it should not.
- Let the machine dry for 24 hours somewhere warm if it has been leaking.
- Check the mains cable and plug for damage and try a different socket on a different circuit.
- If it trips again, or if you cannot find the cause, contact Breville or an authorised service centre. Finding a leak behind panels or testing the element and power board is technician work.
When to stop and call a repairer
This is a mains-electricity fault. Do not open the machine or test live circuits; hand it to a repairer.
What it costs
| Parts | Not published by Breville. Ask an authorised service centre for a quote. |
|---|---|
| Service | Not published by Breville. Ask an authorised service centre for a quote. |
| Worth repairing? | Drying out may be enough. For an element or board on an old machine, get a quote first. |
How to check the error log
Open Settings on the touch screen, then About the Machine, then Software version. On that screen tap each bottom corner of the screen several times. Go back to About the Machine and a new Service center mode entry appears. Open it to view the error log.
Clear the log after a repair so you can tell whether the fault has really gone.
Beyond the fix
Tips and tricks
- Unplug the machine and wipe the outer surface with a soft cloth. Regularly inspect the power cord and plug for damage.manufacturer manual
- On another Oracle model, worn steam wand seals can leak around the tip and the temperature sensor area. A technician swaps the spare O-rings and gasket from the tool tray.technician video
- If the problem persists, call Breville Consumer Support.manufacturer manual
Common mistakes
- Ignoring a visible leak because the machine still brews.
- Filling the tank with hot water, which the manual forbids.
Further reading
Questions
What does E19 mean on the Breville / Sage Oracle Jet?
Leakage current protection triggered multiple times indicating electrical safety fault. The machine detected an electrical fault: leakage current to ground, an unexpected mains waveform, or a heater drawing power when it should not, according to third-party service tables (Breville publishes no code table). Water on a heating element or the power board is a plausible cause. This is the kind of fault that can also trip the GFCI / RCD in your kitchen.
Can I fix E19 myself?
DIY difficulty: not recommended. Unplug. Do not keep resetting the breaker; each trip means current is going where it should not. Let the machine dry for 24 hours somewhere warm if it has been leaking.
How much does it cost to fix E19?
Not published by Breville. Ask an authorised service centre for a quote. Not published by Breville. Ask an authorised service centre for a quote.
Is it worth repairing?
Drying out may be enough. For an element or board on an old machine, get a quote first.
E19 during startup or during use?
Breville / Sage Oracle Jets report E19 any time. There is no reliable pattern to when it appears — treat any occurrence as real.
Can I keep using the machine with E19 showing?
Treat it as a stop-using signal: E19 marks a fault that can damage the machine (or worse) if you keep running it. Do the safe first steps below, then stop.